Operation process of electric cutting mirror operation equipment
1、 Check whether the power plug of each instrument is connected with the instrument, connect the power supply of the instrument, stick the negative plate of the electric knife to the muscle rich place of the patient, and install the foot control pedal.
2、 Once the parameters of the instruments are set, they do not need to be changed
The sequence is as follows: Video Converter → display → cold light source, and the turn-off sequence is opposite.
3、 Connect the unipolar electrocoagulation line, turn on the power switch of high frequency electrotome, and adjust according to the operation needs
The output power of the electric knife.
4、 After wiping the eyepiece end of the camera with lens paper, it is connected with the lens and covered with sterile lens cover,
The other end is inserted into the signal converter interface horizontally to turn on the video signal converter and display switch. 5、Connect the optical fiber to the cold light source interface and turn on the power switch. Adjust the brightness of light source
And white balance.
6. Connect the perfusion pipe to the electric cutting irrigation solution, and turn on the perfusion pipe switch. A kind of
7、 At the end of the operation, the brightness of the cold light source should be adjusted to the minimum value, and then turn off the cold light source in turn Turn off the video switch and the display.
8. Cut off the power supply of the instrument and equipment, register the usage, and return the equipment to its original position after cleaning.
